Here are the steps to edit your Device Overview page.

1.) Using NeoEdit create the .ncf file. The bitmap that is wanted on the Device Overview page should already be in use on another page. This is important because it means the bitmap is included in the .ncf file.

2.) Open the .ncf file using WinZip. Extract the contents. You will notice a file called ConfigEdit.xml and many .bmp files. From the .bmp files, find the one(s) you want on the Device Overview page. Make note of the filename (i.e. bitmap_id40.bmp)

3.) Open the ConfigEdit.xml file in a text editor (WordPad).

4.) Search the text for your bitmap filename (bitmap_id40.bmp). Make note of the number in the line . That bitmap id may always match the file name, but I'd check to make sure.

5.) Now for the tricky part. Starting at the top of the file, find the first occurence of the comment line <!-- Start of Module -->. This is where the start of the Device Overview page is. You will find the following lines grouped together and repeating:






Essentially, each grouping of these four things represent one button. By examining the text in the section, you will find the name of the button
to be replaced. Once found, examine the section. You will see two lines as follows:




Change the "1" to a "40" (Or whatever your bitmap name is). Save the file and exit.

6.) Create a new zip file using the files you previously extracted, including the newly edited file. Give it a .ncf extension. You will need to copy the comment from the original .ncf file and add it to the new Zip file.

7.) Open the newly created file in NeoEdit, and download to you remote. However be careful not to save the file in NeoEdit or it will re-create the Device Overview page.