The following page was printed from RemoteCentral.com:
The following is an archive of information recorded for the Elan System86 (S86, S86AVP) Wiki entry. This version was created by jimstolz76 on Thursday June 4, 2009 at 21:19. (Original Entry)
| | Brand: | Elan |
Device Type: | Multi-Zone Controller |
Model/Series: | System86 (S86, S86AVP) |
Model Year: | Unknown |
Information: | [Link: elanhomesystems.com] |
Configurations: | Search the file area |
| | | | | | Dimensions: | 17.00" wide × 4.13" high × 15.38" deep 43.18 cm × 10.49 cm × 39.07 cm |
| | | | | | Notes: | IR control is implemented through the RJ45 Keypad input jacks. (Brown = Ground, White/Blue = IR signal) There is no IR receiver on the front of the unit, and no IR input on the rear. This unit DOES have global IR commands, so if you wire IR into any of the zone keypad inputs, you can issue any command for any zone.
(6) Zone Trigger Outputs provide 12vdc when a corresponding zone is turned on. They are also programmable in Elan ViaTools so they can alternately be used as programmable trigger outputs that can be triggered via IR.
System Trigger Output provide 12vdc when any zone is turned on.
Source IR outputs route IR from keypad inputs to the selected source component for that zone.
All IR Out passes all IR that comes into the System86.
(6) Sense Inputs allow for conditional statements when used with Elan keypads and Via touchpanels. |
| |
|
|
Input Options
| | Infrared: | Yes |
IR Input Jack: | No |
Radio Frequency: | No |
RS-232 (Serial): | Yes |
Network IP: | No |
Bluetooth: | No |
USB: | No |
DC Trigger: | No |
| | | Output Ports
| | IR Output Jack: | Yes |
RS-232 Output: | Yes |
DC Trigger: | Yes |
| |
| |
|
Discrete Codes
| |
Power: | Yes |
Inputs: | Yes |
Sound Modes: | N/A |
Picture Modes: | N/A |
Screen Modes: | N/A |
| |
| Delays/Timings
| | Power On: | Unknown |
Switch Inputs: | Unknown |
Inter-command: | Unknown |
| |
|
|
|
Important Codes & Commands |
No codes have been added for this model.
|
|
|