| Post 1 made on Thursday October 7, 2004 at 01:22 |
sroyer Lurking Member |
Joined:
Posts: | October 2004
1 |
|
|
Hey gang - i need a remote, preferably touchscreen, that i can control two DISH Network RF receivers independently (different addresses) and can send x10 controls with wither with an IR receiver or again preferably RF commands. All other components are standard. Any advice you great people can give would be great!
|
Scott |
|
| Post 2 made on Sunday January 2, 2005 at 02:28 |
If you change the remote address on the Dish Network boxes (i.e. 1 and 2) and then use a remote like Home Theater Master MX-900 to store the two different codes for each of the units. You could use the RF unit (MX-200) to communicate in RF. For the X-10 you will need to plug the MX-200 to an IR to X10 wall outlet converter.
|
|
| Post 3 made on Tuesday January 4, 2005 at 15:33 |
Anthony Ultimate Member |
Joined:
Posts: | May 2001
28,874 |
|
|
no remote can talk directly in RF with your components. But there are remotes that can talk RF to a base. As touch screens go, I think the good bets are the Pronto TSU-3000 the ProntoPro TSU-7000 and the HTM MX-3000
|
... |
|
| Post 4 made on Tuesday January 4, 2005 at 18:31 |
terrib Lurking Member |
Joined:
Posts: | January 2005
2 |
|
|
HEY....I HAVE A PROBLEM...I HAVE A RCA SYSTEM LINK 4+ UNIVERSAL REMOTE AND OF COURSE I DON'T HAVE THE PAPERWORK ON IT...WAS WONDERING IF ANY 1 COULD TELL ME HOW TO PROGRAM THE CHANNELS INTO IT????
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
