Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
MX-850 and RC-5 codes
This thread has no replies.
Post 1 made on Thursday November 9, 2006 at 17:05
mishamag
Lurking Member
Joined:
Posts:
November 2006
1
I'm trying to program this remote for an Arcam AVR-350. Everything works just fine except for control of Zone 2 (on/off/volume) using the IR codes downloaded from Universal for the AVR-300.

The Zone 2 buttons just don't work properly. If I manually press the Zone 2 button on the receiver I am then able to use the remote buttons successfully. After the receiver is powered down and then turned on again if I do not press the receiver's Zone 2 button the remote's Zone 2 buttons do not seem to work. What happens is if I press the Zone 2 "on" button the receiver briefly switches Zone 2 on, but it kicks out within a split second. I really don't know what to do here. The receivers manual says Zone 2 "on" is controlled by RC-5 system code 16 command 47. Any suggestions how I can try this on my MX-850.

Sorry if this is confusing, but I'm pulling my hair out trying to figure it out.

Thanks!

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse