On November 10, 2009 at 22:09, Palnews26 said...
So, If I have the IR output set to "all" is the blaster is on or off ???
I see the blaster as an option.
I have no identical components so I output RF to all (no IR).
You are not outputting RF. You are outputting IR, you just dont need to route it.
Thanks for the reply.
I never would have found that.
Now I have a clue!
Edit:
I guess its on? As I have it set to all.
Right?
Say I have the TV on Port 1, the Cable box on Port 2 and the Reciever on Port 3 (not sure about the exact ports). Don't I need all three active to watch Cable TV? Same for just about everything else.
Does "All" mean ports only, or blaster and ports.
Is blaster only active when selected?
I don't see any clarifaction in any literature on this subject.
Are you having a problem with the blaster being active? If you aren't routing it shouldnt be a problem unless you are getting overload from IR.
I am downloading CCP to check for you but I know on a regular MX900 file you click the RF button then select receiver in the lower right and turn the IR blaster to OFF.
