Post 1 made on Friday February 27, 2004 at 00:54 |
davidgrove Long Time Member |
|
|
It seems to me that it should be pretty near impossible for X10 signals to be able to get to the protected line voltage outputs of a UPS. I would like to use a UPS in front of some equipment (projector) that I would like to control (on/off only) via X10.
So, is there some way to get X10 signals from the house line voltage side of a UPS to the protected side? Assume for purposes of this question that the UPS produces nice sinusoidual output, rather than square waves or other forms of lots of high frequency noise.
Regards,
DG
This message was edited by davidgrove on 03/01/04 13:03.
|
|
|