I have just got a TS1000 second hand. It would not connect to my PC so I went into the menu and hit Revert. Here's where it started...... I got an error screen that states "Invalid configuration file version" and only one option. A revert button that is meant to set the device back to the original configuration. This just resets the device back to this same screen with a couple of beeps..... Please help....... I have not even had a chance to use this remote yet..

I had an issue where the backlight was broken so I replaced the L1 coil with a 220uh non-surface mount coil and this worked fine until this issue....could they be related....

Things that I have done..

1...Tried to reset
2...Tried to use HyperTerminal - Can not comunicate with device
3...Tried leaving the batteries out - comes back the same
4...Tried to run firmware upgrade - errors because I have not reset properly
5...Tried to use the undead function on tonto - asks for a reset and then stays at 2%
6...Tried to use the firmware upgrade on tonto - asks for a reset and then stays at 2%
7...Just about to try to throw it against the wall.....

Any advice would be greatly appreciated

This message was edited by garethcook on 04/11/05 19:39 ET.