Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Wednesday August 8, 2012 at 09:41
Long Time Member
January 2008
Don't do that much programming but do have the latest MX Editor and database and could use some expert advice from this community.

just yesterday Dish Network installed the new Hopper and (2) Joey's. Needless to say my MX900 will need some new programming.

This morning I went looking for an updated IR database that included the Hopper, Joey and my new TV Panasonic TC-P50GT50 with N2QAYB000703 remote.

Turns out the latest database doesn't include any of this hardware. Sure I'll start trying some similar hardware codes and in worst case start the learning process but I thought I'd ask if anyone has any experience with this newer equipment and if so some advise and a possible solution.

Have seen some comments about the Hopper working with VIP922 codes but again I don't see the 922 in the database.

Thanks for taking the time to read this and really appreciate any comments/advice/suggestions.


Thank You for your help.

Hosting Services by ipHouse