Post 6 made on Sunday July 4, 2010 at 19:15 |
dz- Long Time Member |
Joined: Posts: | October 2007 78 |
|
|
The RFX9600 can give you 4 "hardware" flags if you are not using relays/powersense ports. You can wire the 5v output from the RFX, into a relay and then into a power sense input.
Whenever you do projector power on, close the relay (so voltage goes through it) and the power sense will come on - now your projector is on. Likewise, open the relay when you do projector power off. You can now use that powersense input in your projector on macro, and do "if power sense port is open (not sensing), send projector power on command and wait 25 seconds"... If the projector is already on and the power sense is sensing voltage, it will skip the command and the delay.
No prontoscript required.
|
|
|