Post 1 made on Saturday April 27, 2013 at 17:48 |
I am trying to serial control the Xantech via this HAI device. All wiring tests well. Getting 5.7VDC on TX and 0 across RX connected. Baud rate at 9600. !1SS2+ is my test code in system but no change in software test or uploaded GUI. I've tried /CR...forums and tech docs show no need for null. Firmware across all subsystems are latest...I am at a loss. IR for same device are controlling perfect over iPhone within same program.
Am I missing something?
|
|
Post 2 made on Thursday August 1, 2013 at 09:00 |
jeroenV Long Time Member |
Joined: Posts: | April 2012 15 |
|
|
No !1PR1+ is the code I use with URC to power on my MRC-88. It needs a CR after every command. Try \x0D instead of /CR.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.