Longshot but, does anybody on here have a Grohe Wirless shower and X-10, if so does it work, did you have to anything special to make it work.

Since I installed this shower, non of my x10 gear works

Thanks in anticipation of any help

Mark

Have you tried putting an X10 filter on the Grohe device? Might be putting too much noise on the powerline.

Thanks, I'l see how I can do that.

Slight problem is that the Shower is hard wired, rather than just plugged in, but, I'm sure I'' come up with something

Mark

Years ago, I bought an Advanced Control Technologies RF100 in-line three-wire X10 module. lt's about 1"x1.5"x2.5". (Although the model number says RF, it really is X10 PLC.)

I checked their web site, but the search function wasn't working. Their number is 800-886-2281.

You might give them a try.

Thanks, I'm in the UK but, don't see an issue with sourcing from abroad

Regards
Mark