| Post 1 made on Wednesday April 7, 2004 at 18:15 |
jazzman Founding Member |
Joined:
Posts: | December 2001
365 |
|
|
Anyone active with their 2 ways? It appears to me (not covered in their instructions) that sending a scene address followed by an "off" command always shuts off the scene group. This is a minor problem for me as it requires me to off-load the job of sending the scene command to the HA controller instead of the wall transmitter doing it directly. I want to be able to switch off the button LEDs on 6400s and 16400s to show status of a device (fan,blind,ect) and I can't send an off to these buttons as it cancels the scene if directly addressed. Anyway around this?
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
