| Post 1 made on Friday April 2, 2004 at 22:07 |
I am just trying out x10 for the time being. So I bought fairly inexpensive to get a feel for it and decide if I want to run with it or not.
Ran into a small problem though today with my x10 ws467 wall switches. Seems there is no ground connector on them and my box is a plastic one so I cannot ground to the box either.
Not quite sure what to do about it, as I don't know allot about wiring and am worried about the ground wire not being attached to anything.
|
|
| Post 2 made on Friday April 2, 2004 at 23:41 |
Larry Fine Loyal Member |
Joined:
Posts: | August 2001
5,002 |
|
|
Try extending the bare wire to be held under the plate by one of the screws that hold the switch in the box.
In other words, bend a U in the wire, put the screw through the plate, through the U, and into the hole.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
