Your Universal Remote Control Center
RemoteCentral.com
Lighting & Home Control Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
television and x-10 problems
This thread has 4 replies. Displaying all posts.
Post 1 made on Monday December 1, 2003 at 14:25
ricklynchcorecom
Lurking Member
Joined:
Posts:
December 2003
2
I have a new Samsung tele, it seems to interfere with my x-10 mods. If the tv is on, I have no control over my x-10 mods. Once the cool down fan stops, bang all my x-10 mods again work??

Thanks for any advice

Rick
Post 2 made on Monday December 1, 2003 at 14:49
Clocknut
Long Time Member
Joined:
Posts:
November 2003
34
It sounds like you need a noise filter. Try unplugging (not just turning it off) the TV completely and see if your problems go away. Take a look here for filters: [Link: homeautomationnet.com]

Carter
Post 3 made on Monday December 1, 2003 at 18:59
Deane Johnson
Founding Member
Joined:
Posts:
August 2001
263
I have a Samsung TV and it indeed does mess up X-10. A filter puts a stop to it.

Deane
OP | Post 4 made on Tuesday December 2, 2003 at 08:47
ricklynchcorecom
Lurking Member
Joined:
Posts:
December 2003
2
Do you filter the whole power strip, or just isolate the tv within the power strip.

Rick
Post 5 made on Tuesday December 2, 2003 at 10:34
Deane Johnson
Founding Member
Joined:
Posts:
August 2001
263
I filter the whole power strip, assuming the total load doesn't exceed the ratings of the filter. I purchase mostly the 15 amp filters, so that is unlikely, though I have some 5 amp filters.

These power strips are tricky. I have one that looks like a power strip, but I noticed in the fine print it said something about "clamping voltage". Turns out it was some sort of surge protector and was sucking the X-10 down.

My expereince has been that most surge protectors have a negative effect on X-10 and should always be filtered. Sometimes the effect is not great, but every little bit hurts. I use an ELK meter to double check what something might be doing to the signal.

Deane


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse