Post 1 made on Wednesday October 8, 2003 at 13:35 |
Hello folks,
This might be a previously answered question but I didn't find the answer when I searched the forum. Is there any best House Code setting between A to P? Or it doesn't change anything in terms of performance.
Thanks!
Martin :-)
|
|
Post 2 made on Wednesday October 8, 2003 at 14:32 |
Deane Johnson Founding Member |
Joined: Posts: | August 2001 263 |
|
|
I have never heard anything to indicate there was any difference in performance, but since most components default to A1, I usually don't use it to avoid possible outside interferance from neighbors. I'm assuming A, and possibly the next channel or so might be the most used by others.
Deane
|
|
Post 3 made on Wednesday October 8, 2003 at 23:28 |
Bill E. Founding Member |
Joined: Posts: | July 2001 947 |
|
|
Try to avoide using A1, for anything you are using, as all devices are preset to this out of the box. Also most RF transcievers have A1 as a built in appliance module which you will hear click if you happen to set up a lamp as A1. Bill www.homeautomationnet.com
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.