Post 1 made on Sunday October 5, 2003 at 02:45 |
nu4ea Founding Member |
Joined: Posts: | September 2001 49 |
|
|
hi folks, is it possible to program a macro to use conditional logic to control the times when the motion sensor are to operate. i installed two dm10a outdoor motion sensors, two appliance modules and a cm11a. one sensor in the front of the house and one in the back yard. the front turns ont the front outdoor lights and the rear sensor turns on the back outdoor lights.
let me give you an example. i want the motion sensors to operate only when the sun sets until dawn. not in the day time. i called x10 tech support and they told me the program active home version 1.42 does not have conditional programming. is there another program that will work?
thanks in advance.
|
|
Post 2 made on Sunday October 5, 2003 at 07:37 |
ONEAC Senior Member |
Joined: Posts: | September 2002 1,059 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.