| Post 1 made on Wednesday July 23, 2003 at 05:38 |
I have an old (c.1980?) 6809 single-board computer with a pair of 5.25" floppies built into a terminal. It runs both OS-9 and FLEX. I'd love to use this as an X10 controller, similar to the (Z80) Ocelot. Has anyone done this, or know of any appropriate software?
|
Pchek |
|
| Post 2 made on Wednesday July 30, 2003 at 02:12 |
jazzman Founding Member |
Joined:
Posts: | December 2001
365 |
|
|
Sounds like the Heath microprocessor trainer I learned machine code on. Are you using a higher language or just the Motorola instructions with it?
|
|
| OP | Post 3 made on Wednesday July 30, 2003 at 03:47 |
Hi jazzman. Well, when I was using this and other 6809 based computers, I was programming in both assembly language and in C. But it's been a very long while :-). However, if there's _any_ 6809 software out there to do this job, written for either OS-9, or FLEX, or even stand-alone, I would love to see it!
|
Pchek |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
