Post 1 made on Wednesday April 2, 2008 at 18:36 |
SOUND.SD Loyal Member |
Joined: Posts: | April 2006 5,523 |
|
|
Hello everyone. I am swallowing my pride asking this question so here goes.
I am an absolute newbie to contact closure and relays. Anyone that wants to give a quick lesson feel free but here is my main dilemma. The issue has been discussed in the main forum previously.
I need to loop a 4 minute video and have it continue to loop while any one is in the room.
We will be using:
RTI XP8 RTI RK1-4 (Back up/Override) Honeywell DT-7435C Motion Sensor DVD Player (may change to flash media soon, but not an option for now)
Plan:
Create a "start" macro initiated by the contact closure on the motion sensor that turns on tv, dvd, and starts the dvd loop. In addition a "play" command will be sent every thirty seconds.
Create an event that after 12 minutes (DVD looped 3 times) will trigger a macro to power the system down.
If motion is detected during the 12 minutes a flag will issue the "start" command again (basically just using the play command repeats. If motion is not detected for 12 minutes the flag will issue the "off" command.
Problems:
I dont know how to wire a contact closure. YIKES!
The RTI has a A+B Sense Input and the Sensor has NO (normally open), C (common), EOL (not sure), and NC (normally closed).
Besides a power supply, do I need anything else for the motion sensor? Whitevan?
Is the above macro/flag possible?
|
Bulldog AV - San Diego, CA www.bulldog-av.com[Link: facebook.com] |
|
Post 2 made on Wednesday April 2, 2008 at 23:38 |
Groovit Long Time Member |
Joined: Posts: | February 2008 269 |
|
|
Got you in the other post...
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.