On March 31, 2008 at 11:40, estech said...
Can you list the macro (part)? What do your hex strings
look like?
Otherwise, do you need CR at the end of each string?
0D in hex, \r in ascii
Have you tried adjusting the delay between characters
in the hex string? right-click/edit step
Listing below...
Macro for button: Serial X10 - A9 - Off
Serial Port [CM-232] 5 (4800 8N1): \x04g
Serial Port [CM-232] 5 (4800 8N1): \x00
Serial Port [CM-232] 5 (4800 8N1): \x06c
Serial Port [CM-232] 5 (4800 8N1): \x00
Within each command, the option to allow 0.3s delay is enabled but there is 0ms between characters. Your suggestions are good ones. I'll play some more and see what I can learn.
As far as the CR required, the serial port sniffer should have shown that, I think. I'll try it and see..