|
|
|
RTI Control Systems Forum - View Post
|
|
|
|
|
|
|
The following page was printed from RemoteCentral.com:
How to ramp volume down via 232?
| |
|
Topic: | How to ramp volume down via 232? This thread has 6 replies. Displaying all posts. |
|
Post 1 made on Saturday February 16, 2008 at 15:03 |
cassidycaid Founding Member |
Joined: Posts: | October 2001 256 |
|
|
Denon 2808CI controlled by an RP-6 via CM-232.
First time using 232 on the RP6. How do I get a long burst of volume down (for the power off macro for instance)?
|
Scientific method refers to the body of techniques for investigating phenomena, acquiring new knowledge, or correcting and integrating previous knowledge. |
|
Post 2 made on Saturday February 16, 2008 at 15:06 |
tabascojunkie Long Time Member |
Joined: Posts: | July 2007 255 |
|
|
repeats..or see if there is a command for a discrete volume level that you can send via rs-232
|
|
OP | Post 3 made on Saturday February 16, 2008 at 15:12 |
cassidycaid Founding Member |
Joined: Posts: | October 2001 256 |
|
|
I like it to ramp down when the client pushes system off, so the audio fades out, so a discrete level wont really work.
I don't see a repeat number for 232 via library in ID. I only see a repeat while pressed...
EDIT: For the record, this is programming a system macro to run on the controller.
|
Scientific method refers to the body of techniques for investigating phenomena, acquiring new knowledge, or correcting and integrating previous knowledge. |
|
Post 4 made on Saturday February 16, 2008 at 15:46 |
Springs Super Member |
Joined: Posts: | May 2002 3,238 |
|
|
System Macro... Repeat Steps 26 times----- Denon Volume Down delay .1 ---------
thats pretty much it.
|
|
OP | Post 5 made on Saturday February 16, 2008 at 16:20 |
cassidycaid Founding Member |
Joined: Posts: | October 2001 256 |
|
|
who would have thought it would be so easy...
|
Scientific method refers to the body of techniques for investigating phenomena, acquiring new knowledge, or correcting and integrating previous knowledge. |
|
Post 6 made on Sunday February 17, 2008 at 08:10 |
getcontrol Lurking Member |
Joined: Posts: | February 2008 1 |
|
|
Once you have set the volume up command to the button. Go to rs232 properties and select sustain. This will allow you to ramp as long as you hold the button
|
|
Post 7 made on Sunday February 17, 2008 at 21:03 |
ralliart329 Active Member |
Joined: Posts: | October 2007 655 |
|
|
In the macro editor i used the repeat steps function. choose until button is released.
|
|
|
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|