Post 1 made on Monday November 6, 2000 at 12:42 |
Thinking to marry T2 and an Ocelot. I'd like to pass all Ir through the Ocelot; X10 and A/V. Ocelot is already setup to check the status of the A/V equipment. ( using Smartlinc probes, BOB, SECU16). T2 is only going to trigger the macros in Ocelot via RF. Does it sounds right? Can I feed IRF output port directly to Ocelot AUX IR input? Wonder if possible to communicate with Ocelot via RS232 output from IRF?
Thanks
|
|
OP | Post 2 made on Thursday November 9, 2000 at 17:50 |
Ed,
This is the exact setup I'm using. I tried connecting the IRF-6 directly to the Ocelot IR miniplug, but could not get it to work. It does work by using an IRF-6 IR emitter glued by the Ocelot IR receiver window. The marriage is great. The Ocelot macros are more reliable than the T2. Also, the automation with the BOBs is great.
The RS-232 codes would work but it would be a lot of code to program. Not even sure how to start.
Sam
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.