Hello Everyone,

I have a programming question regarding the programability of the SAT-HD100 unit.

The SAT-HD100 has a built-in Tuner for Over-the-Air Channels. When one runs the auto-program for theses channels, It will display channels as follows:

3.0 (ANLG) 3.1 (DGTL) 6.0 (ANLG)

When I surf through the channels, I am shown Channel 3.0 (ANLG), 3.1 (DGTL) 3.2 (DGTL) 6.0 (ANLG) Etc..

Channel 3.1 has the HD signal and shows the channel in the letterbox format. Channel 3.2 is a digital signal but it shows the channel in the standard Full screen format.

I get this for several of the local channels.

My goal is to block out the analog and Digital signals that are not High Definition.

The add/skip function of the SAT-HD100 allows me to skip/block out the analog channels with no problem. I am however unable to selectively block out channel 3.2, If I block out the digital channels, it blocks out Both 3.1 and 3.2.


I am at the point that taking a sledge hammer to the SAT-HD100 is sounding like a very good idea..


Please help.

Thanks, ASESINO

(always check your 6)