I have a situation with two identical TVs in the same room. When the remote sends a command, both TVs receive the command and process it.

What devices are available that would allow commands to be sent to one TV but not the other? I was thinking something along the line of a device that would receive a command such as "Power On TV A" and would then send the command "Power On" to TV A through a stick on IR emitter or something else that would only send it to TV A, but not to TV B.

Any ideas?

well, you will need to use some type of IR matrix router. Xantech makes one called the RT8. It allows you to send commands to specific units, even a wall of televisions that are exactly the same. BUT...you must make sure the televisions receivers are totaly covered, or your remote controls IR will still control them, thus ruining your day!

Check out www.xantech.com and under products/remote control switcher/RT8..

This message was edited by Matt on 04/20/02 16:20.42.

I have a Niles IR router that I would be willing to sell cheap. It was spec'd for a project and then not used. E-mail at bbeck@orci.com if you are interested.