| Post 1 made on Tuesday October 30, 2012 at 18:25 |
jeffusu Lurking Member |
Joined:
Posts: | October 2012
1 |
|
|
Hi,
I inherited an old surround sound system. A Panasonic SA-HT70. It didn't have a remote, so I bought an RCRPS06GR in hopes of being able to use it. The problem is, the system is set on a sound setting only utilizing two speakers instead of the whole surround sound, and there's not a button to engage that on the remote I bought.
Is there a way to program in "engage surround sound" into a button?
I looked at a thread about how to program in EFC codes, but the remote I bought doesn't seem to have a "setup" button that the thread says to press to activate the programming mode.
Any ideas? Should I return the remote and get a different one? I'm not looking to spend a lot of money on a fancy remote for an old sound system.
Thanks,
Jeff
|
|
| Post 2 made on Tuesday October 30, 2012 at 23:48 |
3FG Select Member |
Joined:
Posts: | August 2009
1,861 |
|
|
The RCA RCRP05B (available at Amazon) will accept EFCs, and can be programmed to work with the Panasonic. Do bear in mind that Panasonic used a lot of subdevice numbers depending on the HT system, so it may take a few tries to get the correct EFC.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
