| Post 1 made on Wednesday February 23, 2005 at 21:53 |
shellyny Lurking Member |
Joined:
Posts: | February 2005
2 |
|
|
Ok all I need is a cheap remote that can program my vcr. All I need to do is set the time and then the times i need to tape certain shows. I dont need to do anything else with the remote. Is this possible? Please help me. thank you.
|
|
| Post 2 made on Thursday February 24, 2005 at 00:37 |
Ron Aronson Super Member |
Joined:
Posts: | June 2002
3,967 |
|
|
Most any remote should work, but it would help if we knew the exact model number of your VCR.
Not knowing where you are located doesn't help us much either.
If you can get to a Walmart, you could try the OneForAll 8810W, about $18, and if it doesn't work you can take it back.
|
|
| Post 3 made on Thursday February 24, 2005 at 13:12 |
The Robman Loyal Member |
Joined:
Posts: | August 2001
6,218 |
|
|
I would recommend that you stick with the One For All brand because that way, even if the remote doesn't have a MENU button (or the MENU button doesn't work) you can probably re-program it using advanced codes.
|
|
|
| OP | Post 4 made on Thursday February 24, 2005 at 19:43 |
shellyny Lurking Member |
Joined:
Posts: | February 2005
2 |
|
|
the VCR is a Sharp, model # VC A5240. It's a little old but works fine. Thanks again for the help.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
