Post 1 made on Friday February 11, 2005 at 12:09 |
dryan1976 Founding Member |
Joined: Posts: | November 2001 28 |
|
|
I purchased an RCA audio/video switching unit (Model: VH915) with a remote control. It has 4 inputs and 1 output with composite/s-video and analog audio jacks. It came with a small peanut shaped remote control. The remote had 4 buttons for the inputs (labled, of course, 1-4) another button that said "scan" and I believe there may have been another button that was similar to a "previous input" button.
Anyways, I only actually need the IR codes for inputs 1 through 4. I'm programming a Pronto TSU2000 so I can use either a .ccf file or just the plain hex codes. Either way, I would be extremely greatful! Thanks.
|
|
Post 2 made on Friday February 11, 2005 at 18:31 |
alfaman Founding Member |
Joined: Posts: | November 2001 145 |
|
|
The One-for-All code for the RCA VH915 is Video Accessory 1564.
Doubt if you will find that pre-loaded in any of their products, but if all else fails you could purchase or borrow one of their upgradable models, get that code downloaded into it, and then use the One-for-All to teach your Pronto the codes.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.