I'm looking for the instructions and codes for a after market single use Zenith remote control I purchased a few years back at either K-Mart or Wal-Mart. The remote only controls a single TV. It is transparent purple on top and clear on the bottom half. It has only 6 buttons which are yellow. The buttons are a small round power button in the top right hand corner, two channel buttons, two volume buttons, and a mute button. The mute button is in the center of the remote bracketed by the channel and volume buttons. The remote is a scant 4-3/4" long and 1-3/4" at the widest part (the head). The only labels inside the battery compartment read "ZENSPGA EIA343 SK64-002" and "43/00". Takes two AAA batteries. The remote would be great for someone in a nuring home to use mainly because of it's small size and simple button layout. If anyone has this remote or something else by Zenith very similar please post the setup instructions and codes for a Sanyo TV.

Maybe not the response you are looking for, but have you tried looking at the weemote senior?

[Link: remotecentral.com]

Maybe this info will help others.

Its very hard to find instructions to use this remote.


1) Press Power and Mute buttons down EXACTLY simultaneously for about 3-4 seconds until light comes and stays on.

2) Enter 3 digit code for your tv (from any Zenith Remote manual or web page).

3) To enter code:

V- = first digit
P+ = second digit
V+ = third digit

Code 123 would be:

V- P+ P+ V+ V+ V+

4) Then press Mute to save the code into the remote.

If the code contains a zero, simply skip that entry button.

These are really nice remotes, but really tough to find instructions to program them.