On September 27, 2007 at 21:47, phlopydawg said...
I just bought a RFX6500. Using a PCF file that worked
OK, I tried to switch my audio & one of my Replay TV units
to RF, leaving everything else IR. File works OK in sim
mode, but when downloaded to TSU3000 it locks up (beeps
until I go to "Devices" screen). Switch everything back
to all IR, all OK. Can a TSU3000 do both IR & RF within
the same file? Does everything have to be all IR or all
RF? Please help! I'm so confused!
Thanks for the responses. I think I need to explain what's going on better.
Replay2 macro = Audio ON, TV ON, Replay2 ON, Audio & TV inputs to Replay2, jump to Replay2 Transport. If all IR works OK. If I set Audio to RF, macro runs OK & AV gear responds properly to commands in both IR & RF. But when Pronto Jumps to Replay2 screen it just beeps constantly & won't respond to hard or soft buttons. If I touch "Replay 2" at top of screen, Pronto jumps to devices page & stops beeping. I can then select Replay2 & Pronto goes to Replay2 Transport screen & all is OK.
Problem affects all my macros. Only Replay unit I wanted to switch to RF is #3 & it has nothing to do with this macro.