Post 1 made on Thursday March 9, 2006 at 22:12 |
Kipp Jones Long Time Member |
Joined: Posts: | January 2006 21 |
|
|
Hi, I have a new Mits HC3000 DLP projector and cannot get the 7000 to send out usable commands. Everything programs fine and I have changed the times of the signal being sent out but no luck. The Mits is totally unresponsive to all commands but when I use the Mits remote, all works fine. Any ideas?
|
|
OP | Post 2 made on Thursday March 9, 2006 at 22:20 |
Kipp Jones Long Time Member |
Joined: Posts: | January 2006 21 |
|
|
I am using my 7000 along with the RF6500 and the Mits HC3000 is the only device I am not using the 6500 on. I am aiming directly at the Mits and using the IR signal.
|
|
Post 3 made on Thursday March 9, 2006 at 23:29 |
Peter Dewildt Loyal Member |
Joined: Posts: | July 2001 6,307 |
|
|
Are you sure that you have not accidentally set the device that contains the IR codes to be RF? It is the device where the codes are stored which matters and it is usually not the same as the device where you push the buttons.
|
Peter Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired) Pronto 2xTSU9600, RFX9400 |
|
OP | Post 4 made on Saturday March 11, 2006 at 15:25 |
Kipp Jones Long Time Member |
Joined: Posts: | January 2006 21 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.