| Post 1 made on Monday March 6, 2006 at 15:46 |
Dallas Long Time Member |
Joined:
Posts: | November 2005
59 |
|
|
hey guys....
anyone had an issue with a pronto before where it will turn on when you put a new battery in it but after a few seconds when it goes into standby mode you cant get it to turn on again without resorting to removing the battery and reconnecting it again?
could this be a software upgrade problem?
cheers
Dallas
|
|
| Post 2 made on Monday March 6, 2006 at 17:31 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
You haven't said which model you have.
Sounds like you need to reload the firmware (using a recent version).
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
| Post 3 made on Tuesday March 7, 2006 at 22:41 |
Do Houde Long Time Member |
Joined:
Posts: | January 2003
13 |
|
|
It does sound like the firmware could be bad. Mine was not soldered very well inside and it went flaky on me. Once i went over everything I have not had a problem since. I don't know if you are handy like that or if you know somebody who is, but they are very simple insde. Any novice with a decent solder tip and some flux can go over all the joints in about 45 min including disassembly for the first time.
|
|
| OP | Post 4 made on Thursday March 9, 2006 at 02:35 |
Dallas Long Time Member |
Joined:
Posts: | November 2005
59 |
|
|
thanks guys - ill try upgrading the firmware
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
