| Post 1 made on Tuesday September 28, 2004 at 14:48 |
Dennis Gipe Long Time Member |
Joined:
Posts: | December 2003
78 |
|
|
I set them up once on my 7000 several monthes ago, and have been traveling all summer. Now I got some new equipment and can't remember how I setup the inputs. My remote only has a toggle switch, but somehow I was able to setup Ant A Ant B etc before. If I look at my other devices it says "learned code". Can anyone tell me how stupid I am, or what i'm overlooking. The hard codes for 1277 work but it only has a source code. I don't think I got the codes from someone else, but I might of. I looked for someone else in files useing that tv, but to no avail. Any help would be greatly appreciated.
|
|
| Post 2 made on Tuesday September 28, 2004 at 16:45 |
ddarche Mr. RemoteQuest |
Joined:
Posts: | February 2002
2,309 |
|
|
I have discretes for my Mit WS-65909 that should work on your Mit. You can get them in my configs in the Files area here. I think the 7000 config is most up to date. You can then paste these into your IT codes buttons.
Dave D'Arche
|
Dave D'Arche http://RemoteQuest.comFine Home Theater Remote Controls & Solutions - Programming services for most remotes |
|
| OP | Post 3 made on Tuesday September 28, 2004 at 20:03 |
Dennis Gipe Long Time Member |
Joined:
Posts: | December 2003
78 |
|
|
Thanks for answering, but your codes would not work on my 65411. Thanks again.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
