Post 1 made on Thursday September 23, 2004 at 19:04 |
ddogg3 Long Time Member |
Joined: Posts: | April 2004 19 |
|
|
Well, this is a real weird one. While dimming a lite with my 7000 via IR into an IR543, I noticed that the receive lite on the IR543 was staying on an unusually long time. Upon further experimentation, I noticed that while on the numeric keypad screen only, if I pressed the designated device (ex.#2) and then pressed the dim button, it would first send a short burst as it normally does. If I pressed again, it sent a burst between 2 & 4 seconds which completely dimmed the lamp. I suspect it may be a corrupt code or possibly a problem with the pronto itself ,as it is not a consistantly repeatable command. Sometimes , repeated presses do no more than the standard short burst, and other times I get the long burst. I will continue to investigate this to see if I can determine any pattern.What is most interesting though is that regardless of the cause, it appears their is some way to get long commands out of the Pronto. For reference, this started after I learned the codes directly to the 7000 from my old TS1000 which sent longer commands. I'll keep you all posted.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.