Hallo!

I can control lights of my living room via an infrared remote (Vimar). I've only two buttons:

BUTTON 1) switch on lights and dimmer them up.
BUTTON 2) switch off lights and dimmer then down.

So every button has two functions, depending on the way that I press them.

For example for button 2, if I press continously the button, lights start dimmering down; if I give to the same button a "little" pressure then lights switch off.

Here is my question! How can I reproduce the same effect with my Pronto?

Thanks for your help!

Luciano

Luciano,

By "little pressure" I assume you mean a quick or single tap on the button. If so, you may be able to reproduce this effect depending on how you learn the codes to your Pronto. When learning, press and HOLD (as opposed to a quick tap) the original remotes button until the Pronto acknowledges that it's learned the code.

When the button is held, it's repeating the signal continuously, when tapped, it only sends the code once.

bomberjim,

thanks very much for your answer!
I've strongly appreciated!

Luciano!