| Post 1 made on Sunday February 8, 2004 at 21:11 |
alfaguy Lurking Member |
Joined:
Posts: | February 2004
3 |
|
|
I set up my pronto (TSU 1000) about a year ago, and all was working well. I made some changes using pronto edit today. I then tried to (re)learn a couple of functions.
It seems that the remote won't accept any codes. It simply beeps, and says "FAIL" or something to that effect.
Fortunately, I backed up the CCF before I started so it is working at the moment.
What am I doing wrong? Has some part of the remote died? Do I have to send it out for remedial help?
TIA,
Jeff
|
|
| Post 2 made on Sunday February 8, 2004 at 21:15 |
bomberjim Super Member |
Joined:
Posts: | September 2001
3,894 |
|
|
Forgive me if this is insulting, but the typical cause is learning to the wrong end of the remote. The learning eye is at the rear of the Pronto. Jim L 
|
Jim L  |
|
| OP | Post 3 made on Sunday February 8, 2004 at 21:52 |
alfaguy Lurking Member |
Joined:
Posts: | February 2004
3 |
|
|
ummm .... errr - ugh, I guess it is I who needs the remedial help :-)
Thanks, I did say it was a year or so since I messed with this, so I did in fact forget something obvious.
Thanks again,
Jeff
|
|
| Post 4 made on Monday February 9, 2004 at 10:37 |
Anthony Ultimate Member |
Joined:
Posts: | May 2001
28,878 |
|
|
most common mistake, don't worry about it
|
... |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
