Hi... just got a pronto ru940 and trying to put some of the tasty buttons etc on it but having no luck. everyone i d/l from this site just gives the error message that it can't be done.
if anyone can point me in the right direction it would be great....

Cheers

What gives you an error message?

You can't download from the files section?

If not, then wait a hour or so. It does that every now and then.

Or once you do download, you can't load it into ProntoEdit?

Did you unzip the file before loading it into ProntoEdit?

What ProntEdit are you using? It should be PE V 4.05
Which can be downloaded from this site as well. Of course you must unzip it as well. After install restart your pc, even though it doesn't say to.

Rob

What kind of "error message", what does it say? Does it happen during download, when you attempt to unzip the file, or when you try to open the ccf in Pronto Edit?

Jim L.

Thanks Guys.... the problem is as follows..

Can download the ccf file from the site ok. Unzip and open in PE with no worries. It's when I try to download anything onto the RC that I get the error message (Error downloading onto RC)..
It's fine uploading from RC to computer, all panels etc are there but if I even change the spelling of a panel name and try to download back onto RC I get the error message. The help file on PE doesn't give much advise. Thanks chaps.

The standard advice is to tap the screen JUST before attempting communications with the remote. Many times its necessary to wake-up the remote before downloading.

By the way, interesting handle. In the states, bubbabat conjures up an image of a small flying mammal probably from the less populated areas of Arkansas, Mississippi, Alabama, or Georgia. ;-)

Jim L

LOL thanks mate... I'll give it a go and see what happens. Will post reply a little later. Thanks for your help.

J