Post 1 made on Sunday June 3, 2012 at 11:56 |
hello, I have an installation working with nevolink + nevoSL. My nevoSL is old and does not work well. I was wondering if it is possible to use an iPad as a remote control while keeping the nevolink installation as it is. Does anyone knows how to do that? Is there an app (roomie?) I can use? Thank you (I'm from Switzerland)
|
|
Post 2 made on Sunday July 15, 2012 at 05:13 |
Sorry my bad english. I'm from Russia. It's possible to use NevoLink with iPad. Part-I (NevoStudio) You need some tcp/ip sniffer: SmartSniff good choice. Google it. Configure smartsniff [Options->Display Filter] add in textbox: include:remote::14010 1.Start Nevo studio load config and run Emulator. 2.Click SmartSniff green arrow and start capture hex commands by pressing nevo sl buttons. 3.Wright it down each of them. Ok. Now you have all your ir codes in "NevoLink hex format". Part-II (iPad) Any smart remote app can send hex to nevolink via tcp. 1.CommandFusion iViewer4 - best app. 2.iRule 3.iRidiumHD and so on. Part-III (Conclusion) When i send commands to nevolink via iViewer4 the ir codes endless repeating. So i make Advanced Actions: OnPress - send raw hex e.g. \x00\xBC\xAC\x0D\x00\x0A\x10\x00\x73\x02\x00\x00\x00\x00\x0F\xC8\x00 OnRelease - send \x00 it stops repeating.
GoodLuck
|
|
Post 3 made on Thursday April 2, 2015 at 16:18 |
Hi there, what does the 14010 code mean? Is that a unique code to your device or is it a general code for the Nevo SL? Thanks
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.