| Post 1 made on Tuesday December 31, 2002 at 13:15 |
SBCat Lurking Member |
Joined:
Posts: | December 2002
1 |
|
|
I’ve had my ProntoNeo for about two weeks now and have found a problem, or possibly a defect in my unit. When I upload from the remote to NeoEdit, some of the IR codes for the hardbuttons don't upload. Instead, they all revert to the "Channel Down" code (from the codeset for my Hughes SAT receiver). The hard buttons on the Neo remote still work fine at that point. But if I do additional editing on the uploaded file and then download it to the Neo without reassigning the IR codes again, then the incorrect codes go into the Neo. So I have to reassign them each time I do an upload. What a pain.
Anyone run across this? I am using the latest firmware version and the latest version of NeoEdit.
|
|
| Post 2 made on Wednesday January 1, 2003 at 19:31 |
RWI Founding Member |
Joined:
Posts: | December 2001
592 |
|
|
I am not sure but I think I remember having this problem a long time ago, try learning the problem buttons off of the oem remote, All of my buttons are learned and I have no problems. Hope this helps...
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
