| Post 1 made on Monday September 9, 2002 at 11:21 |
djcigar Founding Member |
Joined:
Posts: | March 2002
15 |
|
|
Am in the process of adding X-10 lighting to my Pronto. Got a low battery alarm last night - so I uploaded the config I was working on and saved it. Pulled the old batteries out and replaced with new. This am, I used the "learn IR" feature once and then was distracted for about an hour. When I came back the unit seems dead. Pulled the batteries and replaced. It beeps four times after a few seconds and then nothing else. I've tried to push the setset button. Although I can hear the click - it doesn't seem to do anything. Any ideas?
|
|
| Post 2 made on Monday September 9, 2002 at 11:25 |
Anthony Ultimate Member |
Joined:
Posts: | May 2001
28,878 |
|
|
1) this is the Pronto NEO forum. You will probably get better responses in the Pronto forum.
2) is it dead or does it beep? If it beeps (signs of life) try reflashing the firmware (update Pronto in PE)
|
... |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
