Post 1 made on Monday June 17, 2002 at 22:23 |
I have applied the most recent firmware changes, and have started to program my own screens. When I uploaded my new screens, the mode screen has the macro and learn buttons disabled. I have tried reverting back to factory settings and uploading the original file back to the remote and I am still not able to use those two buttons ( the buttons are dimmed out ). Is there any suggestions on fixing this problem.
|
|
Post 2 made on Tuesday June 18, 2002 at 00:30 |
allamand Founding Member |
Joined: Posts: | October 2001 513 |
|
|
It is normal, as you are on the Device Overview.(at least I hope so, if not it's broken). Try picking a device and then see if they are "Dimmed out" As far as using the "Revert" button...never did see it do a thing for me..
-steve
|
-steve |
|
OP | Post 3 made on Tuesday June 18, 2002 at 16:16 |
Thanks That was the problem. Very new with the unit still trying setup my screens for system.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.