Post 1 made on Sunday July 17, 2005 at 08:42 |
tried the whole day to get the netx to connect to ipronto and it doesnt work! followed everything according to the two lines that was printed on the manual, and when i press apply at the configuration page it closes my netx connection and the detect page shows nothing. tried dhcp, tried allocating different ip addresses and still no answer.
any suggestions? danke
|
|
Post 2 made on Sunday July 17, 2005 at 14:41 |
SirKalle Long Time Member |
Joined: Posts: | January 2003 130 |
|
|
Hi,
the NetX must bei in "config mode" - there is a tiny button used with a pencil on the back. Then the light of the NetX must change (see manual).
I tried it three times until it worked .... but it worked :-)
Do you "see" a NetX in the iPronto config screen?
Best regards,
Kalle
|
|
OP | Post 3 made on Monday July 18, 2005 at 09:47 |
yes tried it lots of times config mode for the two products but i always get the same msg - "closing netx connection" on the ipronto. am thinking is the netx faulty?
|
|
Post 4 made on Thursday July 28, 2005 at 12:28 |
I have the same problem. After two days nbo success :(
|
w |
|
Post 5 made on Thursday July 28, 2005 at 12:28 |
At the end of two days I solved :)
This message was edited by proedit on 07/28/05 14:23 ET.
|
w |
|
OP | Post 6 made on Monday August 1, 2005 at 04:32 |
am curious how you did it. i got it communicating as well, but it is a strange method involving pluggin out the power and pressing the configuration at the same time. am pretty sure this is not the proper way of doing it.
|
|
Post 7 made on Monday August 15, 2005 at 04:24 |
dvwebster Long Time Member |
Joined: Posts: | August 2004 71 |
|
|
The NetX can get confused if things go wrong during its configuration. Try resetting it to the factory settings by pressing and holding its Config button for 10 seconds. Then try again. In busy Wi-Fi networks it may help to shutdown other Wi-Fi devices during config. Also be sure to have the NetX physically close to the iPronto as it communicates directly with it - NOT via the Wi-Fi Access Point - during the config operation. (After config it does revert to comms via the WAP)
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.