Post 1 made on Thursday February 8, 2007 at 01:39 |
gx270 Long Time Member |
Joined: Posts: | September 2005 194 |
|
|
I just purchased a Harmony 1000 to test out and the remote is locked up.
It just stays at the image of a clock with the green status bar at the bottom. It moves until it reaches the middle and it locks up every time.
I tried downloading the firmware again, but it won't connect. I can send a remote config. but it just locks up everytime. Is there a way to do a reset on this thing?
Anyone else have this issue?
Thanks in advanced.
|
|
OP | Post 2 made on Friday February 9, 2007 at 17:44 |
gx270 Long Time Member |
Joined: Posts: | September 2005 194 |
|
|
Ok, so I got my Harmony 1000 working. I spoke with a tech in tier 2 support. Basically, for now he said that any time you are going to be updating the 1000, launch the program using the shortcut they provide. (For you dealers out there don't manage your Harmony 1000 accounts through the website.)
Just click the Harmony desktop and you will be good to go.
A new verison is coming soon and after it is release you will be able to manage account through the dealer site.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.