Post 1 made on Friday April 19, 2002 at 14:21 |
Midnightsun Founding Member |
|
|
Can anyone out there who has a ExpressVu 5100 or Dish Network 501 PVR confirm that the ff and rewind buttons on your harmony are in fact sending those commands. The reason I am asking is that mine does not work and the codes on harmony's data base, according to harmony are correct. I cannot digitze the signal to work with my unit, since the remote sends in UHF.
Never mind. I just found out that even if the remote says UHF in big letters on it, it also sends ir commands at the same time and I was able to digitize them.
This message was edited by Midnightsun on 04/20/02 21:32.36.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.