| Post 1 made on Thursday April 18, 2002 at 21:57 |
Matt Founding Member |
Joined:
Posts: | August 2001
1,802 |
|
|
|
| Post 2 made on Monday April 22, 2002 at 08:56 |
jarmstrong Founding Member |
Joined:
Posts: | March 2002
1,780 |
|
|
Matt,
I am not sure that any discrete inputs exist but I did decode the only Sanyo projector that has a ccf file for someone in another newsgroup. Perhaps you may use the commands below as a starting point. The power command is two different commands issued sequentially; NEC2 device 48 command 0 followed by NEC2 device 48, sub-device 206, command 255.
Power:
NEC2:48,0/NEC2:48.206,255
The rest are all
NEC2:48,
Command
1 DZoom+
2 DZoom-
5 Input
9 Vol+
10 Vol-
11 Mute
12 Image
15 Select
28 Menu
29 Right Arrow
30 Left Arrow
31 Normal
64 Lens
67 Freeze
70 Zoom-
71 Zoom+
74 Focus+
75 Focus-
91 Keystone
137 AutoPC
You don't mention what remote you are using. If it is a Pronto you can use a Hex generator like John Fine's MakeHex that can generate the missing codes for NEC2 device 48.
I would also contact Sanyo and ask for the codes. Sony publishes their codes for LCD projectors. Keep in mind that If you experiement with all 256 codes you may get into a service mode and could reset a factory alignment or color adjustment etc.
Finally many LCD projectors have RS-232 interfaces that have commands available not found on IR remotes. Again, if you have one, ask Sanyo for the codes.
HTH,
Jon
This message was edited by jarmstrong on 04/22/02 08:58.11.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
