On May 17, 2019 at 11:41, Trunk-Slammer -Supreme said...
The worst thing I see is guys not knowing about the bend ratio on any of this data wire.
Take a piece of Cat 7 and have it make a really tight turn coming out of a top, or bottom, plate and you can reduce it to a nice low speed wire run since you have completely changed the relationship between the pairs. May as well tie a few knots in the wire.....
Ever see a bundle of cables passing over the edge of a beam, dimensional lumber with nice, crisp edges or a piece of bent sheet metal that was screwed to the framing?
I keep scraps of smurf tube, to pass the cables through or to add afterward, by cutting a slit and screwing it to the wood to ease the bend.