| Post 1 made on Sunday December 7, 2003 at 18:51 |
roddymcg Loyal Member |
Joined:
Posts: | September 2003
6,796 |
|
|
Anybody have discrete inputs for this model. I have posted in the discrete section and searched far and wide for the discretes for this specific model. I have went through the codes that jarmstrong posted (thanks) but no good. I also have called Fujitsu (what are discretes) and e-mailed their tech support. No response!
Thanks Fujitsu, our profits on this job are going down the toilet with all the sevice calls we are going on.
Roddy
|
When good enough is not good enough. |
|
| Post 2 made on Sunday December 7, 2003 at 19:10 |
studiocats1 Long Time Member |
Joined:
Posts: | February 2003
482 |
|
|
Thank yourselves for using equipment that you are not sure you can control properly. Don't blame Fujistu for your design shortcomings! :)
|
|
| OP | Post 3 made on Sunday December 7, 2003 at 19:29 |
roddymcg Loyal Member |
Joined:
Posts: | September 2003
6,796 |
|
|
We have used several Fujitsu plasmas without any problems in the past.
Its not like we just decided to use a Fujitsu and hoped that it would work out okay. I do blame them for at the very least being inconsistant, which has made things difficult for us.
Roddy
|
When good enough is not good enough. |
|
| Post 4 made on Sunday December 7, 2003 at 20:31 |
quest51459 Founding Member |
Joined:
Posts: | September 2001
197 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
