| Post 1 made on Wednesday August 27, 2003 at 03:22 |
ronan Lurking Member |
Joined:
Posts: | August 2003
2 |
|
|
I reset a dmr-e10 to factory defaults and changed the remote control code to "set code 2" I do not have a remote that will operate this code set and cannot access the "initial settings" menu from the box itself.
Can I reset the unit by pressing a combination of keys etc?
|
|
| Post 2 made on Thursday August 28, 2003 at 03:20 |
Ernie Bornn-Gilman Yes, That Ernie! |
Joined:
Posts: | December 2001
30,104 |
|
|
You talk about initial settings, then you talk about resetting. Do you mean the same thing both times?
What was your plan for using the unit once you changed it to code 2? All I can think of is that you have two in the same area on two different systems and you will operate this one by hand....
|
A good answer is easier with a clear question giving the make and model of everything.
"The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw |
|
| OP | Post 3 made on Thursday August 28, 2003 at 12:03 |
ronan Lurking Member |
Joined:
Posts: | August 2003
2 |
|
|
Initial settings is a menu accessible through the remote control unit. Since I cannot access this menu without a functioning RC. I was inquiring if this unit could be reset without a remote, similar to the way a satellite receiver can.
I have more than 2 Panasonic devices in my system. I changed the code set so I would not operate both units at once. Unfortunately I picked the wrong set.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
