| Post 1 made on Thursday August 7, 2003 at 23:55 |
lowvoltguy Long Time Member |
Joined:
Posts: | September 2002
176 |
|
|
Has anyone been having problems with these? I've had several problems with them ... Bad out of the box ... Relaibility ... Is this just a bad luck streak for me or what???? I think the A-BUS product is a good fit for a lot jobs, but I'm getting hesistant to sell any more local sources ...
|
|
| Post 2 made on Sunday August 10, 2003 at 13:55 |
Stephen Coates Long Time Member |
Joined:
Posts: | June 2003
155 |
|
|
I've had problems. But I've cracked it now.
The problem I had was my fault.
I was using too much pressure punching down and with the wrong tool.
I now use the correct tool and don't press to hard.
Hope this helps.
|
|
|
| Post 3 made on Monday August 11, 2003 at 14:38 |
Rmirabal Long Time Member |
Joined:
Posts: | October 2002
20 |
|
|
Don't forget to adjust the sensitivity and delay.
Sensitivity controls the amount of signal the local source needs in order to "switch" on.
Delay is the time it takes to "switch" back to the main source once it loses the local signal.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
