|Post 1 made on Sunday November 10, 2019 at 21:46|
Going crazy. I have a tsu 9400 purchased used a few years ago, been working great until tonite. I moved one button in my config (pep2) from one page to another, downloaded config. Now some hard buttons not sending ir signal.
buttons not working are, mute - ok - menu - volume+ - left dot - right dot - power. If I send test code from my database it works. I tried reset, home - menu -page up no good. I removed battery no good. Is there a reset button on unit? Any help would be appreciated. 9400 specs application 5.0.6 ir firmware 3.0.11
|OP | Post 2 made on Sunday November 10, 2019 at 22:07 |
Working correctly now not sure about fix powered unit off for 20 mins then downloaded again works.
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.