I am at present setting up multiple TSU9600,s with PFX9600's controlling a Bticino system, with the MyHome web server
Because of the amount of addresses required for all devices,the system has dual networks. I can get the Pronto to talk to the first system, but not to the second.
I have tried entering the numbers 0,1 and 2 into the interface section of the parameter page to no avail.
All A/V control is working fine thru the RFX's and Cisco routers.
If I leave the INT section blank in the parameters page of the module the Pronto controls lights, curtains etc in System 1, but as soon as I enter a value into that line I lose the lot.
Has anyone had experience with dual Bticino networks. HELP!!

You use more than 200 IP addresses?

Can you communicate with both networks with a laptop?

Usually a device that is on a network can not communicate with devices that are on another network unless there is a router between the networks and it this case the solution should be quite trivial.

The router works as a gateway, that handles teh transition between the two networks. The pronto should not care how many networks are there around it is the same fot it, it just calls an ip address if it doesn't fint it on it's own network it handles the address to the router that does the work. Because otherwise the pronto would not be able to surf the web.

Make sure there all on the same subnet.

Yes, you can communicate with both networks with a laptop setting the interface to 1 for the second network. Thanks for your earlier answer

Do you mean the Bticino networks?

Hi Blu Phoenix,
thanks for your help. I got everything to work fine today. My next task is to create a macro that Turns the cinema lights off when I turn the Projector,amp etc on and vice versa when powering down the equipment.
Can I do this with the MyHome MH200. I've never done this before and don't know how to create a macro with both Bticino and Pronto commands
Cheers

I am not familiar with Bticino, but with the pronto it should not be a problem.

Take a look at prontoscript and you'll see that the things you have in mind are pretty trivial to make. Sorry, but can't help you in a better way for now.