Finally took the plunge and upgraded several remotes to a tsu9600 the question is how can I move all my codes and screens to the 9600 is it even possable. Trying to save hours here I don't see a import function in v2 of the software.

I'm sure this was discussed before but I couldn't find it.

Thanks ahead of time,
jason

Can't speak for PEP v2, but in PEP v1 you can import your PCF via File->Import PCF. I have not so much as downloaded PEP v2 and don't plan on doing so.

Import into PEPV1 and then you will need to convert your config to use database codes.

Then, pull it into PEPV2. Note that your graphics will ALL need to be resized/redone.

See here:

[Link: remotecentral.com]

and

here:

[Link: remotecentral.com]

I suggest reading the stick threads in the Pro forum in their entirety. They may not apply to you now, but they will likely apply later.

And, converting all your code pages into a database will take some time. Instead of saving hours, you added hours by starting with PEPv2. If it were me, until I needed functionality only supported by PEPv2 (common editor for all remotes and support for TSU9800), stick with PEPv1. In fact, I have PEPv2 installed but only use it for TSU9800.